Development Trends in Weaving

Authors

  • Stana Kovačević Faculty of Textile Technology University of Zagreb, Department of Textile Mechanical Technology, Zagreb, Croatia https://orcid.org/0000-0003-1466-3174
  • Josip Hađina Faculty of Textile Technology University of Zagreb, Department of Textile Mechanical Technology, Zagreb, Croatia
  • Damir Vitez Varteks, Varaždin, Croatia
  • Krste Dimitrovski University of Ljubljana, Faculty of Natural Sciences and Engineering, Department of Textiles, Ljubljana, Slovenia

Abstract

At the ITMA 2003 no revolutionary novelties in weaving were seen. Improvements of quality, automation and cost-effectiveness of weaving as well as ergonomic improvements of machine construction and simple operation are observable. The possibility of applying warp beam of a 1.6 m diameter and direct warp patterning by transfer printing on the weaving machine are being developed. Weaving speeds have not been considerably increased, and the highest development potential lies in air-jet multi-phase weaving.

Downloads

Published

2004-04-30

Issue

Vol. 53 No. 4 (2004)

Section

Conference paper

License

Copyright (c) 2004 Hrvatski inženjerski savez tekstilaca

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
Kovačević, S. et al. 2004. Development Trends in Weaving. Tekstil. 53, 4 (Apr. 2004), 161–168.

Most read articles by the same author(s)

1 2 3 4 5 6 > >>