Process Parameters of Cutting of the Layers with Band Knife Cutting Machine

Authors

  • Dubravko Rogale Faculty of Textile Technology University of Zagreb, Department of Clothing Technology, Zagreb, Croatia https://orcid.org/0000-0002-3104-8096
  • Mile Nikšić Faculty of Textile Technology University of Zagreb, Department of Clothing Technology, Zagreb, Croatia

Abstract

The article reports on the whole mathematical derivation and on the final expressions which unite technical and technological parameters of cutting of the cutting layers by using band cutting machines. On the basis of mathematical expressions, the computer program is given for the simulation os the process of cutting of the layers with band knife cutting machines. Five various kinds of technical diagrams with graphically presented interdependences of technical and technological factors were obtained. The simulation was carried out for the cutting velocity from 0 to 0.4 m/s, for the velocitiens of band knife from 0 to 40 m/s and for the grinding angles of band knife from 4 to 32°.

Downloads

Published

1992-03-31

Issue

Vol. 41 No. 3 (1992)

Section

Original scientific paper

License

Copyright (c) 1992 Hrvatski inženjerski savez tekstilaca

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
Rogale, D. and Nikšić, M. 1992. Process Parameters of Cutting of the Layers with Band Knife Cutting Machine. Tekstil. 41, 3 (Mar. 1992), 107–113.

Most read articles by the same author(s)

<< < 1 2 3 4 5 6 7 8 9 10 > >>